Resource Menu


posted by Benoit Thiebault at Oct 7, 2008 3:50 PM
Quote
This problem comes from GMSH and your geometry… Not sure I can help… It seems however that you try to define a ruled surface with points that are coplanar… Check out your sphere definitions…
posted by Aleksandra Chudnovskaya at Oct 4, 2008 7:37 PM
Quote
And it writes before warnings:

Info : Swapped 42 edges Info : Swapped 23 edges Info : Swapped 10 edges Info : Swapped 6 edges Info : Swapped 2 edges Info : Swapped 1 edges Info : Swapped 0 edges Info : Boundary edges recovery Info : Volume = 2.744 Info : =================================================== : Number of missing edges = 66 : =================================================== Info : 1/66: Edge 4->2 => 2 division(s) Warning : If the mesh is still correct after this, contact us

What does it mean? I don't understand :(

Thank You again,

Aleksandra

posted by Aleksandra Chudnovskaya at Oct 4, 2008 7:21 PM
Quote
Hello! I have the same problem with mesh 3D, but in SPIS 3_6. When I call the mesher, it begins to write warnins: Warning : Coplanar points in circum sphere computation Warning : (0.2027,0.136334,0.056981) (0.20685,0.1335,0.067) (0.2027,0.136334,0.056981) (0.2027,0.136334,0.056981) Warning : Coplanar points in circum sphere computation Warning : (0.2027,0.136334,0.056981) (0.20685,0.1335,0.067) (0.2027,0.136334,0.056981) (0.20685,0.1335,0.067)

and etc. It may do it during 24 hours untill I quit the programm. Can You help me? Thank You, Aleksandra