posted by Ignacio Rocca at Sep 30, 2009 10:28 PM
Quote
I'm affraid you have to prepare a difference simulation for each tool
Ok, can you tell me where can I find some guide or manual to prepare a simulation to picUp3D with SPIS?
Thanks for your time
Ignacio
posted by Benoit Thiebault at Sep 30, 2009 10:14 PM
Quote
I'm affraid you have to prepare a difference simulation for each tool
posted by Ignacio Rocca at Sep 30, 2009 10:05 PM
Quote
PicUp3D is a PIC simulation software that was created before SPIS by Julien Forest.
You can find out more on PicUp on the dedicated web site http://dev.spis.org/projects/spine/home/picup.
There are a lot of differences between the two software.
SPIS uses unstructured mesh while PicUp3D uses cartesian structured mesh. The models differ as well.
SPIS is more configurable and offers more possibilities for S/C charging modelling
Regards
Thanks Benoit, my question now is, can I simulate the same project with every simulator? Or I need pre-process every project before the simualtion.
Best Regards
Ignacio
posted by Benoit Thiebault at Sep 30, 2009 9:18 PM
Quote
PicUp3D is a PIC simulation software that was created before SPIS by Julien Forest.
You can find out more on PicUp on the dedicated web site http://dev.spis.org/projects/spine/home/picup.
There are a lot of differences between the two software.
SPIS uses unstructured mesh while PicUp3D uses cartesian structured mesh. The models differ as well.
SPIS is more configurable and offers more possibilities for S/C charging modelling
Regards
posted by Ignacio Rocca at Sep 30, 2009 7:28 PM
Quote
Hi, are there some diference between SPIS-UI and PICKUP-3D simulation?, did someone ran both simulations on SPIS? Thanks for your time!
Ignacio