Resource Menu


posted by Sébastien Hess at Jun 21, 2016 9:39 AM
Quote
All outputs are given in physical particles, except when it is explicitly stated that it concerns macroparticles (i.e. only for the macroparticle number per cell).
posted by Till Gebhardt at Jun 9, 2016 6:10 PM
Quote
Yes, now the simulation is running. Thanks a lot for this tip.

The erosion values can now derived by looking at the "flux of eroded source 1.1"? The dimension "#/m2/s" gives the number of particles eroded per second and square meter. Are these macroparticles or actual physical particles?

posted by Sébastien Hess at Jun 6, 2016 4:19 PM
Quote
If you try to set it to 2, does the simulation work?
posted by Till Gebhardt at Jun 1, 2016 2:34 PM
Quote
Hi Sebastien,

yes, it is currently set to 4.

posted by Sébastien Hess at Jun 1, 2016 1:30 PM
Quote
Hello,

do you have a global parameter called fluxChargeState and if so what is its value?

Sebastien

posted by Till Gebhardt at Jun 1, 2016 12:32 PM
Quote
Hello,

I try to model the erosion by a Hall thruster. The modelling of the thruster works fine. But as soon as switch on the erosion calculation the simulation stops always after the same time step giving following error message:

spis.Util.Exception.SpisRuntimeException: Units are not convertible: cannot scale from unit m-2.s-1 to m-2.A at spis.Util.Phys.Unit1.getDoubleScalingFactorTo(Unit1.java:500) at spis.Util.Phys.Unit1.getScalingFactorTo(Unit1.java:493) at spis.Util.Func.ConvertibleUnitScalFunctionOfScal.checkAndSetUnitIn(Co nvertibleUnitScalFunctionOfScal.java:72) at spis.Util.Table.FloatScalTable.applyFunc(FloatScalTable.java:346) at spis.Surf.SurfField.ScalSurfField.applyFunc(ScalSurfField.java:165) at spis.Util.Monitor.FieldMonitor.generateLogData(FieldMonitor.java:1626 ) at spis.Util.Monitor.FieldMonitor.generateSurfData(FieldMonitor.java:159 7) at spis.Util.Monitor.FieldMonitor.monitorCurrent(FieldMonitor.java:864) at spis.Util.Monitor.FieldMonitor.monitorCurrent(FieldMonitor.java:788) at spis.Util.Monitor.FieldMonitor.monitor(FieldMonitor.java:748) at spis.Top.Simulation.SimulationFromUIParams.integrate(SimulationFromUI Params.java:3881) at spis.Top.Simulation.SimulationFromUIParams.integrate(SimulationFromUI Params.java:4020) at spis.Top.Top.Scenario.integrate(Scenario.java:106) at spis.Top.Top.NumTopFromUI.integrate(NumTopFromUI.java:180) at org.spis.ui.simulation.command.LaunchSimulationCommand$1.run(LaunchSi mulationCommand.java:91) at java.lang.Thread.run(Unknown Source)

Did it anybody have a similar issue or can give me some insight what might be reason?

Greetings, Till Gebhardt