Resource Menu


posted by julien at May 4, 2005 4:08 PM
Quote
At least this last point is solved with Jyconsole.

ju.

posted by julien at May 4, 2005 4:08 PM
Quote
Initially posted Fri Oct 22, 2004 8:59 am by thiebault, forwarded by juju. ___

Another thing : this log window that deletes the history after a certain number of lines is not very practical… is there a solution

posted by julien at May 4, 2005 4:08 PM
Quote
Extracted from old forums

Previously posted by Thiebault: Fri Oct 22, 2004 10:59 am Post subject: Another thing : this log window that deletes the history after a certain number of lines is not very practical… is there a solution ?

posted by julien at May 4, 2005 4:08 PM
Quote
Extracted from old forums.

Previusly posted by Thiebault: Wed Oct 20, 2004 5:36 pm Post subject: Wish list for SpisUI

Here is a list of features that would require an improvement in SpisUI :

  • When saving a project, if you click on the "cancel" button, it saves your project anyway...
  • When you load your project, even if you saved it before meshing your spacecraft (i.e. after the steps OpenCAD>LoadCAD>Prop>EditGroups), it crashes due to a problem in the execution of the "TaskLoadProj.py" script
  • When you do your simulation normally, and then try to relaunch the Global parameters editor, in order to modify some parameters, via the UI to Num button, it doesn't launch the window. You have to open it manually via the Solver menu
  • When you do 2 simulations after each other without relaunching the framework, the 2D plot menu "Curviline datafield" gives you the choice between two curves (whose names are, by the way, too long to be read completely and therefore differenciated). But whatever curve you choose, you always have the results of the last simulation… maybe an overwriting problem ?
That's all folks ! (for the moment) Benoit